#include <ethercat_hardware/wg0x.h>#include <ethercat_hardware/wg_soft_processor.h>#include <pr2_msgs/PressureState.h>#include <pr2_msgs/AccelerometerState.h>#include <ethercat_hardware/RawFTData.h>#include <geometry_msgs/WrenchStamped.h>

Go to the source code of this file.
| struct WG06StatusWithAccel __attribute__ | ( | (__packed__) | ) |
| uint8_t accel_count_ |
| uint16_t board_temperature_ |
| uint16_t bridge_temperature_ |
| uint8_t digital_out_ |
| int32_t encoder_count_ |
| int32_t encoder_index_pos_ |
| uint8_t encoder_status_ |
| uint8_t ft_sample_count_ |
| uint16_t l_finger_tip_[22] |
| int16_t measured_current_ |
| int16_t motor_voltage_ |
| uint16_t num_encoder_errors_ |
| uint16_t packet_count_ |
| int16_t programmed_current_ |
| int16_t programmed_pwm_value_ |
| uint16_t r_finger_tip_[22] |
| uint8_t sample_count_ |
| uint16_t supply_voltage_ |
| uint32_t timestamp_ |