Flags management functions

Flags management functions. More...

Collaboration diagram for Flags management functions:

Functions
void	PWR_ClearFlag (uint32_t PWR_FLAG)
	Clears the PWR's pending flags. More...
FlagStatus	PWR_GetFlagStatus (uint32_t PWR_FLAG)
	Checks whether the specified PWR flag is set or not. More...

Detailed Description

Flags management functions.

 ===============================================================================
                    ##### Flags management functions #####
 ===============================================================================  

Function Documentation

void PWR_ClearFlag

(

uint32_t

PWR_FLAG

)

Clears the PWR's pending flags.

Parameters

PWR_FLAG

specifies the flag to clear. This parameter can be one of the following values: PWR_FLAG_WU: Wake Up flag PWR_FLAG_SB: StandBy flag

Return values

None

Definition at line 654 of file stm32f4xx_pwr.c.

FlagStatus PWR_GetFlagStatus

(

uint32_t

PWR_FLAG

)

Checks whether the specified PWR flag is set or not.

Parameters

PWR_FLAG

specifies the flag to check. This parameter can be one of the following values: PWR_FLAG_WU: Wake Up flag. This flag indicates that a wakeup event was received from the WKUP pin or from the RTC alarm (Alarm A or Alarm B), RTC Tamper event, RTC TimeStamp event or RTC Wakeup. An additional wakeup event is detected if the WKUP pin is enabled (by setting the EWUP bit) when the WKUP pin level is already high. PWR_FLAG_SB: StandBy flag. This flag indicates that the system was resumed from StandBy mode. PWR_FLAG_PVDO: PVD Output. This flag is valid only if PVD is enabled by the PWR_PVDCmd() function. The PVD is stopped by Standby mode For this reason, this bit is equal to 0 after Standby or reset until the PVDE bit is set. PWR_FLAG_BRR: Backup regulator ready flag. This bit is not reset when the device wakes up from Standby mode or by a system reset or power reset. PWR_FLAG_VOSRDY: This flag indicates that the Regulator voltage scaling output selection is ready.

Return values

The	new state of PWR_FLAG (SET or RESET).

Definition at line 627 of file stm32f4xx_pwr.c.