address_is_readable.cc
Go to the documentation of this file.
1 // Copyright 2017 The Abseil Authors.
2 //
3 // Licensed under the Apache License, Version 2.0 (the "License");
4 // you may not use this file except in compliance with the License.
5 // You may obtain a copy of the License at
6 //
7 // https://www.apache.org/licenses/LICENSE-2.0
8 //
9 // Unless required by applicable law or agreed to in writing, software
10 // distributed under the License is distributed on an "AS IS" BASIS,
11 // WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
12 // See the License for the specific language governing permissions and
13 // limitations under the License.
14 
15 // base::AddressIsReadable() probes an address to see whether it is readable,
16 // without faulting.
17 
19 
20 #if !defined(__linux__) || defined(__ANDROID__)
21 
22 namespace absl {
23 namespace debugging_internal {
24 
25 // On platforms other than Linux, just return true.
26 bool AddressIsReadable(const void* /* addr */) { return true; }
27 
28 } // namespace debugging_internal
29 } // namespace absl
30 
31 #else
32 
33 #include <fcntl.h>
34 #include <sys/syscall.h>
35 #include <unistd.h>
36 #include <atomic>
37 #include <cerrno>
38 #include <cstdint>
39 
41 
42 namespace absl {
43 namespace debugging_internal {
44 
45 // Pack a pid and two file descriptors into a 64-bit word,
46 // using 16, 24, and 24 bits for each respectively.
47 static uint64_t Pack(uint64_t pid, uint64_t read_fd, uint64_t write_fd) {
48  ABSL_RAW_CHECK((read_fd >> 24) == 0 && (write_fd >> 24) == 0,
49  "fd out of range");
50  return (pid << 48) | ((read_fd & 0xffffff) << 24) | (write_fd & 0xffffff);
51 }
52 
53 // Unpack x into a pid and two file descriptors, where x was created with
54 // Pack().
55 static void Unpack(uint64_t x, int *pid, int *read_fd, int *write_fd) {
56  *pid = x >> 48;
57  *read_fd = (x >> 24) & 0xffffff;
58  *write_fd = x & 0xffffff;
59 }
60 
61 // Return whether the byte at *addr is readable, without faulting.
62 // Save and restores errno. Returns true on systems where
63 // unimplemented.
64 // This is a namespace-scoped variable for correct zero-initialization.
65 static std::atomic<uint64_t> pid_and_fds; // initially 0, an invalid pid.
66 bool AddressIsReadable(const void *addr) {
67  int save_errno = errno;
68  // We test whether a byte is readable by using write(). Normally, this would
69  // be done via a cached file descriptor to /dev/null, but linux fails to
70  // check whether the byte is readable when the destination is /dev/null, so
71  // we use a cached pipe. We store the pid of the process that created the
72  // pipe to handle the case where a process forks, and the child closes all
73  // the file descriptors and then calls this routine. This is not perfect:
74  // the child could use the routine, then close all file descriptors and then
75  // use this routine again. But the likely use of this routine is when
76  // crashing, to test the validity of pages when dumping the stack. Beware
77  // that we may leak file descriptors, but we're unlikely to leak many.
78  int bytes_written;
79  int current_pid = getpid() & 0xffff; // we use only the low order 16 bits
80  do { // until we do not get EBADF trying to use file descriptors
81  int pid;
82  int read_fd;
83  int write_fd;
84  uint64_t local_pid_and_fds = pid_and_fds.load(std::memory_order_relaxed);
85  Unpack(local_pid_and_fds, &pid, &read_fd, &write_fd);
86  while (current_pid != pid) {
87  int p[2];
88  // new pipe
89  if (pipe(p) != 0) {
90  ABSL_RAW_LOG(FATAL, "Failed to create pipe, errno=%d", errno);
91  }
92  fcntl(p[0], F_SETFD, FD_CLOEXEC);
93  fcntl(p[1], F_SETFD, FD_CLOEXEC);
94  uint64_t new_pid_and_fds = Pack(current_pid, p[0], p[1]);
95  if (pid_and_fds.compare_exchange_strong(
96  local_pid_and_fds, new_pid_and_fds, std::memory_order_relaxed,
97  std::memory_order_relaxed)) {
98  local_pid_and_fds = new_pid_and_fds; // fds exposed to other threads
99  } else { // fds not exposed to other threads; we can close them.
100  close(p[0]);
101  close(p[1]);
102  local_pid_and_fds = pid_and_fds.load(std::memory_order_relaxed);
103  }
104  Unpack(local_pid_and_fds, &pid, &read_fd, &write_fd);
105  }
106  errno = 0;
107  // Use syscall(SYS_write, ...) instead of write() to prevent ASAN
108  // and other checkers from complaining about accesses to arbitrary
109  // memory.
110  do {
111  bytes_written = syscall(SYS_write, write_fd, addr, 1);
112  } while (bytes_written == -1 && errno == EINTR);
113  if (bytes_written == 1) { // remove the byte from the pipe
114  char c;
115  while (read(read_fd, &c, 1) == -1 && errno == EINTR) {
116  }
117  }
118  if (errno == EBADF) { // Descriptors invalid.
119  // If pid_and_fds contains the problematic file descriptors we just used,
120  // this call will forget them, and the loop will try again.
121  pid_and_fds.compare_exchange_strong(local_pid_and_fds, 0,
122  std::memory_order_relaxed,
123  std::memory_order_relaxed);
124  }
125  } while (errno == EBADF);
126  errno = save_errno;
127  return bytes_written == 1;
128 }
129 
130 } // namespace debugging_internal
131 } // namespace absl
132 
133 #endif
#define ABSL_RAW_LOG(severity,...)
Definition: raw_logging.h:42
Definition: algorithm.h:29
#define ABSL_RAW_CHECK(condition, message)
Definition: raw_logging.h:57
bool AddressIsReadable(const void *)


abseil_cpp
Author(s):
autogenerated on Tue Jun 18 2019 19:44:35