control_msgs/JointTolerance Message

File: control_msgs/JointTolerance.msg

# The tolerances specify the amount the position, velocity, and
# accelerations can vary from the setpoints.  For example, in the case
# of trajectory control, when the actual position varies beyond
# (desired position + position tolerance), the trajectory goal may
# abort.

# There are two special values for tolerances:
#  * 0 - The tolerance is unspecified and will remain at whatever the default is
#  * -1 - The tolerance is "erased".  If there was a default, the joint will be
#         allowed to move without restriction.

string name
float64 position  # in radians or meters (for a revolute or prismatic joint, respectively)
float64 velocity  # in rad/sec or m/sec
float64 acceleration  # in rad/sec^2 or m/sec^2

Expanded Definition

string name
float64 position
float64 velocity
float64 acceleration